samshaver18
Junior Member
Today I installed a scosche 2 channel LOC-80 in my 1998 Jeep Grand Cherokee Laredo. I used the front speakers to connect the LOC. I cut the RF +, RF-, LF +, LF -, stripped the ends and twisted two leads together. Then I took the LOC wire and put it into a butt connector and crimped it, and took the twisted wire and put it on the other side of the butt connector and crimped it. I did the same for each wire. I made sure I matched the wires from the LOC to the stereo wiring. I connected the RCA into the LOC and put the dash back together. Then I tested the Stereo. and only the back speakers work.
Other things to note. The RCA is not plugged into an amp because I am putting my subs and amp in tomorrow. The only reason I plugged the RCA in now is because the dash is such a pain to take off.
I also have after market speakers that I installed Monday and have had no problems. If anyone could tell me what is wrong and what I need to do to fix it that would be very much appreciated, Thanks!
Other things to note. The RCA is not plugged into an amp because I am putting my subs and amp in tomorrow. The only reason I plugged the RCA in now is because the dash is such a pain to take off.
I also have after market speakers that I installed Monday and have had no problems. If anyone could tell me what is wrong and what I need to do to fix it that would be very much appreciated, Thanks!