Amp problem

  • 2
    Participant count
  • Participant list
yea but later on im going to disconnect every wire, and try it on my friends wires if it does the same i think i might open it up and check or just buy a new one.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
3
784
Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
2
729
If a sub's voicecoil fails, it will usually drop impedance causing too much current to go back to the amplifier. The amplifier then protects...
15
2K
Have you checked the fuse block. With time, tight connections can loosen and cause failure. Refresh those contact points and test again. Remember...
1
1K
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
161

About this thread

sq_joshua

Junior Member
Thread starter
sq_joshua
Joined
Location
los angeles
Start date
Participants
Who Replied
Replies
2
Views
747
Last reply date
Last reply from
sq_joshua
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0

New threads

Top